ELF+4( Ív'U1WVS D$t$8|$@9ʋwC29t B9v|$Du@T$01L$1|$$D$l$ D$Ǻ@T$,D$ 0D$D$0$D$ǍD$ C2D$D$D$0$D$ǍD$D$D$0$D$Ǹ1D$D$0$D$NjCHD$:D$D$0$D$ǺK Ɔ ,V<m$D$ [^_]Ðt&VS8$D\$8Fh$t$$t$$1ۉt$ 3C~5u 8[^$11ۉL$\$D$ $$9w&'FhYD$4FjD$0FdD$,NEЉT$(F`KD$$D$ FTD$FHD$eata_pio: int_handler, freeing locked queueslot <5>eata_pio_queue target %d, pid %ld, HBA busy, returning DID_BUS_BUSY, done. <0>eata_pio: run out of queue slots cmdno:%ld intrno: %ld <4>eata_pio_abort called pid: %ld target: %x lun: %x reason %x <4>eata_pio: abort, queue slot locked. <4>eata_pio: abort, command reset error. <4>Returning: SCSI_ABORT_BUSY <4>Returning: SCSI_ABORT_NOT_RUNNING <4>eata_pio: abort, timeout error. eata_pio: abort: invalid slot status <4>eata_pio_reset called pid:%ld target: %x lun: %x reason %x <4>eata_pio_reset: board reset done. <4>eata_pio_reset: interrupts disabled, loops %d. <4>eata_pio_reset: exit, wakeup. <4>eata_pio_reset: reset ccb %d. <4>eata_pio_reset: slot %d in reset, pid %ld. <4>eata_pio_reset: exit, already in reset. eata_pio_reset: slot %d, sp==NULL. Please check values: (read config data) LEN: %d ver:%d OCS:%d TAR:%d TRNXFR:%d MORES:%d HAAV:%d SCSIID0:%d ID1:%d ID2:%d QUEUE:%d SG:%d SEC:%d IRQ:%d IRQT:%d FORCADR:%d MCH:%d RIDQ:%d eata_pio: executing controller self test & setup... Can't support more than one HBA on this IRQ, if the IRQ is edge triggered. Sorry. Couldn't allocate IRQ %d, Sorry. HBA at %#lx didn't react on INQUIRY. Sorry. HBA at %#.4lx supports DMA. Please use EATA-DMA driver. <5>eata_dma: No valid IRQ. HBA removed from list eata_pio: invalid base address of device %s EATA (Extended Attachment) PIO driver version: %d.%d%s (c) 1993-95 Michael Neuffer, neuffer@goofy.zdv.uni-mainz.de Alfred Arnold, a.arnold@kfa-juelich.de This release only supports DASD devices (harddisks) HBA no. Boardtype: Revis: EATA: Bus: BaseIO: IRQ: Ch: ID: Pr: QS: SG: CPL: scsi%-2d: %.10s v%s 2.0%c %s %#.4x %2d %d %d %c %2d %2d %2d EATA (Extended Attachment) PIO driver1b scsi%-2d: HBA %.10s Firmware revision: v%s IO: PIO Base IO : %#.4x PCI EISAISA Host Bus: %s Attached devices: %s none%ceata_pioEATA-PIORegistered HBAs: j j j j pj j pj j pj j j j j j j j j j ppj pj j j j pj j j j j j pj j j j j pj j j pj pppj j j j j ppppj pj pppj j j j j j j j j j pj j j j j j j j pj j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j pj j j pj pppj j j pj j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j j pGCC: (GNU) 3.3.3 (PLD Linux).symtab.strtab.shstrtab.rel.text.rel.data.bss.modinfo.rodata.str1.32.rodata.str1.1.rel.rodata.note.GNU-stack.comment@ 85)` % ;@/ @ 4 "=2` M2&`&\ @;X h`*x`*~*-P 1e $-5 ?OXb js,0@ @@@l@N    o$:vK[luE}P0l  ` a>"1"BjSdr~p[`+4@N@Oaeata_pio.c__module_kernel_versionISAbasesISAirqsEISAbasesregistered_HBAslast_HBAfirst_HBAreg_IRQreg_IRQLint_counterqueue_counterbuff.0buff.1print_selftestdriver_templateinit_this_scsi_driverexit_this_scsi_driver__module_licenseeata_pio_set_infoeata_pio_proc_infosprintfproc_print_scsideviceeata_pio_releaseioport_resource__release_regionfree_irqIncStatdo_eata_pio_int_handlereata_pio_int_handlerprintkeata_pio_queuescsi_command_sizepaniceata_pio_aborteata_pio_resetjiffiesget_pio_board_dataget_pio_conf_PIO__check_regionprint_pio_configregister_pio_HBA__request_regionscsi_registerrequest_irqfind_pio_ISAfind_pio_EISAfind_pio_PCIpci_find_devicepci_enable_devicepci_set_mastereata_pio_detectscsicam_bios_param__this_modulescsi_register_modulescsi_unregister_moduleinit_modulecleanup_moduleeata_pio_send_command 4cu &8J\gy~ y"#$r'%4%(%%n%% l* ) (w ~  +  (! & (; @ (N S (c h (s x (  +  ( " (2 .A ._ d (  (  ( ! (4 9 (S X + "1 (jy(( )(TY((f/"45"#(&6 !1(CTa(030!>3GL(:;<03'Jkz(987 ($)(05(:(,&56D?IO_@ezAALPT=\!l),->  $(,048<@DHLPTX\`dhlptx|  $(,048<@DHLPTX\`dhlptx|  $(,048<@DHLPTX\`dhlptx|  $(,048<@DHLPTX\`dhlptx|